1. Remove all components from the Peli Case.
  2. Place the stage base on a flat surface.
  3. Connect the power cable below.
  4. Slide the vertical post with the alignment plate at the rear into the stage slot.
  5. Tighten the vertical post by attaching the manual lever.
  6. Slide the light frame into the vertical post.
  7. Tighten the light frame with using the manual clamping lever.
  8. Connect each light module using the manual clamping levers from the inside of the light frame to the light module thread.
  9. Slide the camera mount into the vertical post.
  10. Tighten the camera mount with the manual clamping lever.
  11. Adjust all parts if needed and secure all connections safely.
  12. Connect a camera to the camera mount.
  13. Connect the light power cables and secure the loose cables.
  14. Connect the USB cable to the stage and PC.
  15. Power on the perClass stage.