Dependencies

See the plugin dependencies for either the Pleora eBUS plugin or the Photonfocus plugin.

Configuration

System

By default the camera uses a link-local IP address. In this case the computer's Ethernet interface should then either be set to DHCP or a static IP address in the range 169.254.0.0/16, for instance 169.254.1.1 with subnet mask 255.255.0.0.

mira.ini

The Headwall MV.C NIR has the following options available in the mira.ini file under the acq_HeadwallMVCNIR section:

  • shutterMode: an integer value to define the shutter mode, possible values: 0 and 1, defaults to 1, only needs to be changed to 0 on older units.

External

Some camera settings are not configurable through perClass Mira, but may be configured through eBUS Player or PFViewer.


WARNING: Do not modify the DeviceUserID, StatusLineCustomValue0, or StatusLineCustomValue1, these registers contain calibration information.

Troubleshooting

For issues with loading the plugin, see Plugin loading. For other issues with GigE based cameras, see GigE Vision.